Publicité
Operating Instructions
MaxLite 8ft Vapor Tight - LSV Series
®
CEA-RDW Adapter Installation Instructions
General Wiring Diagram
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Vaux-
Vaux+
DIM-
(Gray/Pink)
DIM+ (Purple)
0-10V DIM LED Driver
LED- (Black)
LED+ (Red)
1.
Remove the lens and the LED board to expose the LED driver. Drill a hole on one of the ends using the ½"
2.
knockout hole pattern on the fixture.
Run the wires from the adapter through the knock out hole of the fixture and attach the adapter using the
3.
locking nut. Ensure that the adapter is facing downwards after the fixture is installed.
Connect the wires according to the general wiring diagram (FIG). Re-attach the LED board and the lens to
the fixture.
© Copyright 2021 MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Fixture
Lock Nut
Purple
Adapter
Gray/Pink
Yellow
L
N
GND
LSV Series
Page: 11
REV: 10/29/21
Publicité
