MaxLite LSV Serie Mode D'emploi

Operating Instructions
MaxLite 8ft Vapor Tight - LSV Series
®
General Safety Information
• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards read all
warnings and instructions included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
• For Residential installation: If you are unsure about the installation or
maintenance of the luminaires, consult a qualified licensed electrician
and check your local electrical code.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet
metal or other sharp objects.
• Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
• DO NOT INSTALL DAMAGED PRODUCT!
• Suitable for Dry or Damp location
WARNING:
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture
to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label
information.
• Make all electrical and grounded connections in accordance with the National Electrical
Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved wire connectors.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing,
servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
NOTE: Green ground screw provided in proper location.
Do not relocate.
NOTE: Minimum 90° supply conductors.
NOTE: Specifications and dimensions subject to change without
notice.
NOTE: Suitable for Dry or Damp location.
This instruction manual applies to the LSV Series
Models:
© Copyright 2021 MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
LSV Series
Picture is for illustration purposes
only. Your model may vary.
Included in the box:
• LSV Vapor Tight Fixture
• Instructions
• Brackets (3)
• V-Hooks (3) & hardware
Page: 1
REV: 10/29/21