Publicité
www.elektromarkabolt.hu
Operation
Starting Operation
u
u
u
Switching On/Off
To switch on the measuring tool in line operation, push
the on/off switch (1) to the — position, and in point opera-
tion, push to the ● position. Immediately after being
switched on, the measuring tool sends a laser beam out of
outlet aperture (5) (line operation) or (11) (point opera-
tion), depending on the operating mode selected.
u
To switch off the measuring tool, push the on/off
switch (1) to the centre position.
u
28 | English
Protect the measuring tool from moisture and direct
sunlight.
Do not expose the measuring tool to any extreme
temperatures or variations in temperature. For ex-
ample, do not leave it in a car for extended periods of
time. In case of large variations in temperature, allow
the measuring tool to adjust to the ambient temperat-
ure before putting it into operation. The precision of the
measuring tool may be compromised if exposed to ex-
treme temperatures or variations in temperature.
Avoid substantial knocks to the measuring tool and
avoid dropping it. Damaging the measuring tool can
cause accuracy to be compromised. If the laser line is
subjected to a substantial knock or is dropped, check it
by comparing it to a known horizontal or vertical refer-
ence line.
Do not direct the laser beam at persons or animals
and do not stare into the laser beam yourself (even
from a distance).
Never leave the measuring tool unattended when
switched on, and ensure the measuring tool is
1 609 92A 8KK | (24.02.2023)
Bosch Power Tools
Publicité
