Publicité
Pairing a new device AMPLICALL
AMPLICALL
Note : When you receive your AMPLICALL
with the AMPLICALL
are paired already. So, you do not need to follow
the following steps.
To pair a new device, please follow these steps:
Step 1: Enter pairing mode for the AC100 Press & hold the LEARNING button (
for 3 seconds. The LED in zone icon #1 will flash.
Step 2: Press the LEARNING button (
pair with.
Press the melody selector ( ) button to scroll through the melodies. Once you
hear a melody you like, do not press any button during the melody.
Step 3: Once the zone icon and melody are selected, press one time on device (AC101,
AC110 or AC140) button to pair. If successful, the AC100 will generate two
short tones.
Press the LEARNING button (
ready to use
To stop the Chime while the AMPLICALL
located at the top back.
Deleting one device from the AMPLICALL
- First, press and hold the 'Learning' button for 3 seconds to enter pairing mode.
- Press the 'Learning' button to select the zone you want to delete.
- Press and hold both the ' Learning' and the ' Melody' buttons for 3 seconds.
- The AMPLICALL
been deleted.
- Press the Reset button at the back to exit.
Charging the melody/tone of the desired zone icon
- First, press and hold the 'Learning' button for 3 seconds to enter pairing mode.
- Press the 'Learning' button to select the zone icon you want to change.
- Press the 'Melody' button to select the new melody/tone and then press learning
button. You will hear a tone to indicate the modification was successful.
- Press the Reset button at the back to exit.
TM
100
TM
101 doorbell, the devices
Zone selector
Learning button
Melody selector
TM
100 will generate a tone to indicate the device for this zone has
TM
101/110 or 140 with
TM
100
●
) again to move to the zone icon you wish to
●
) to exit the pairing mode; the system is now
TM
100 is alerting, press the reset button
5
TM
100 memory
●
)
Publicité
