Publicité
Battery installation in the remote
1. Use your finger to unlock the
lock lever (fig
2. Rotate the mounting bracket to
90 degrees (fig
3. Remove the mounting bracket
from the unit (fig
4. Rotate the battery cover using
a coin (fig
).
5. Insert a CR2032 battery into
the battery compartment with
the polarity + on top. (fig
6. Close the battery cover using
a coin. (fig
7. Replace the mounting bracket
to 90 degrees. (fig
8. Rotate the mounting bracket until the part locks.
WALL MOUNTING
You can install your AMPLICALL
Please, follow the recommendations below.
4. Screw three screws into the plugs, hang the base on the support and slide it to the
left to lock it.
).
).
).
).
).
).
TM
100 onto a wall.
4
1. Place the wall
support against the
wall and mark the
three holes of the
wall support on the
wall.
2. Drill two holes
horizontally, 36 mm
apart, and drill the
third hole between
the 2 holes at 13.5
mm above the
virtual line between
the first two holes.
3. Insert three wall
plugs fixing into the
three holes.
Publicité
