Anti-Tip Bracket Installation - Haier BC100GS Guide De L'utilisateur

English

Anti-tip bracket Installation

1. Take off upper hinge cover with upwards motion. Refer to illustrations below:
2. Take the anti-tip bracket and screws from the accessory bag. Tighten the anti-tip
bracket on the top of the product with screws as follows in the illustration.
Note: Follow instructions properly or you may do damage to product.
3. Pull glass door open and attach the anti-tip bracket to counter by screw as seen
below. Adjustment of the leveling legs under the unit may be necessary for a proper
fit in the cabinet opening. Start with the rear legs (if necessary) before you slide the
unit fully into the opening –rise or lower the rear legs to make the unit fit properly.
Then carefully slide the unit into opening as not to damage accidently cabinetry or
the floor. Then perform the same adjustments to the front leveling legs to bring the
front of unit to the proper level to install the anti-tip bracket and fit evenly under the
counter.
4. Another set of anti-tip brackets for side installation is provided as option when
the counter top is granite and hard to fix by screw. This set of brackets include one
bracket and four screws for installation on left side if the cabinet when the door is
left-open or on the right side of the cabinet when the door is right-open. Below draft
illustrates the installation procedure.
6