Publicité
To remove/avoid waterdrops and condensation/fog, these tips might help :
All manuals and user guides at all-guides.com
•
Spit or lick the port or housing lens. The water will sheet off instead of beading up!
•
Apply a water repellent and anti-beading/ anti-fog coating or wax (such as 'RAIN-X)
•
Make sure the inside of the housing and camera is as dry as possible (e.g. dry hands,
no sweat) to prevent fog/condensation
•
Don't leave the camera in the direct sun or near heat and don't leave it on
(generating heat) when not necessary
•
Open the fogged camera housing and carefully wipe off the fog inside, then close it again
•
Try to avoid too large temperature differences as these may cause condensation/fog
Note: Muffled sound is inevitable when using the camera with the waterproof housing.
MOUNTING THE CAMERA USING THE
Attaching the camera to any mount, is always done in the same way:
1. Place the camera on the mount's screw 2. Rotate/point the camera as desired
MOUNTS WITH ADHESIVE TAPE
How to apply the adhesive tape (IMPORTANT!)?
•
Apply the tape 24 hours before use
•
Make sure the surface you want to apply the tape on is smooth: the tape will not
adhere properly on an embossed or poreus surface.
•
Clean and dry the surface before application. Any cleaner that will not leave a film
or oily surface can be used!
•
Press the tape entirely and firmly into place!
DELIVERED MOUNTS
and fasten with the tightening screw
3. Tilt the camera into the desired
shooting angle and fasten with the
tightening screw
11
Publicité
