Publicité
SOURIS G15IBM1.qxd
All manuals and user guides at all-guides.com
9. Description of the RF receiver
not cancel connection mode manually, the receiver reverts to Normal mode after 15
seconds.
Status and Connect Indicator Lights
These indicator lights inform you of the methods of functioning and the connection
between the receiver and the transmitter(s). Here are the various statuses displayed :
Remains off when the receiver is functioning in Normal mode and no
device is transmitting.
Flickers rapidly when the receiver is functioning in Normal mode and a
synchronised device is transmitting.
10. Problem Situations
Symptom
The mouse indicator light goes on when the
activation button is pressed, but the receiver
does not respond.
When you use the mouse in space, the cursor is
visible, but does not move.
The cursor moves abnormally.
The mouse's indicator light blinks when the
activation trigger is pressed.
The mouse's indicator light is off when the
activation trigger is pressed.
The cursor moves too quickly, or too slowly.
The cursor drifts on the screen.
The mouse's indicator light does not blink when
on the charging support : the mouse does not
charge.
The battery runs down too quickly.
23/08/05
Connect Button
Press the Connect button.The RF
receiver blinks to indicate that it is in
connection mode, enabling a device to be
synchronised with the receiver. If you do
Status
Reason
Mouse and receiver not synchronised.
The (gyroscope) mouse is not activated.
Radio interference.
The battery is under-charged.
The battery is run down.
The mouse is switched off.
Speed or acceleration incorrectly set.
Sensor not working.
Dirty contacts.
The battery is run down.
Mouse being used on a dark surface.
8
18:17
Page 8
Connect
Blinks rapidly (one blink per second) when the receiver is in
Connection mode and is awaiting a connection instruction from a
device.
Remains on when a device is connected.
Solution
Carry out synchronisation (§ Installation of the
mouse and the RF receiver).
Press or double-click on the activation trigger
located under the mouse.
Move the receiver away from other electronic
equipment (e.g. : monitor, speakers, radio, etc.).
Recharge the battery.
Recharge the battery.
Switch the mouse on.
Change the cursor's speed of movement in the
mouse's configuration panel.
Put the mouse on the desk for 4 seconds or
more to stabilise the cursor.
Clean the contacts under the mouse.
Replace the battery.
Use the mouse on a light surface so as to avoid
draining the battery too quickly.
Publicité
