Publicité
The Refrigerator is designed to be either free-standing or built-in. It has motorized
fans at the back of the unit that direct compressor-generated heat away from the
compressor and through the front of the unit. Keep the front vents unobstructed. If the
unit is built-in, allow minimum clearances of 1/4" at the sides, 1/2" at the back and 1" at
the top.
Once the Refrigerator is positioned, the adjustable legs should be turned to level the
appliance. This will reduce vibrations.
Door Handle Installation
The door has four screw holes on each side allowing you to install the
handle (provided with the refrigerator). Using a Phillips screwdriver,
remove the four screws pre-installed on the side of the door. Align the
handle with the screw holes and attach with the four screws. Tighten screws
firmly but do not over tighten.
Reversing the Door Swing
Tools needed: Flathead screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the refrigerator or disconnect power.
To remove door from hinges:
1. Using a flathead screwdriver, separate the hinge axis from Hinge 1. Set aside.
2. Open the door about 20°around the axis of Bottom Hinge 2, then lift the door off
Bottom Hinge 2 and set door aside.
To replace door on hinges:
3. Using a flathead screwdriver, remove the plug buttons from the screw holes
opposite the door hinges, top and bottom. Set aside.
6
Publicité
