Publicité
To adjust the temperature, press the SET button, then use the UP/DOWN keys to
navigate to the preferred temperature. The range of set temperatures is from 36 to
64° F. For example, if you are storing red wine, you may want to set a temperature of
61º F. When the correct temperature appears in the DISPLAY window of the control
panel, press SET to confirm. The actual temperature inside the unit will now appear in
the window. This temperature will vary depending on the number of bottles stored
and how frequently the door is opened.
Please note: The temperature sensor records the average temperature of the unit.
Cold air falls and warmer air rises, and there will be a temperature variation from the
bottom to the top of the unit. The temperature at the bottom of the unit will always be
slightly colder. The controller only controls the average temperature of the unit. The
temperature displayed by the electronic control panel is the instantaneous average
temperature of the unit and there may be a variation of approximately 0 to 6
Fahrenheit degrees.
When fully loaded with room temperature product, the BLZ-SSRF-50DH will operate
continuously for as long as 24 hours to reduce the temperature inside the cabinet to
the desired point. Under normal conditions, when the unit has been on for six hours, it
will stop working for about thirty minutes to defrost automatically.
The unit is designed to operate between 50°F (10℃) and 100°F (38℃). Higher ambient
temperatures may reduce the unit's ability to reach low temperatures. Best results are
obtained at temperatures between 65°F and 80°F for built-in models and between
65°F and 90°F for freestanding models.
Caution: Damages caused by ambient temperatures of 40°F (4℃) or below are not
covered by the warranty.
To temporarily stop the cooling cycle, unplug the Refrigerator. To shut it down for
longer periods of time, disconnect the plug and leave the door partially open.
NOTE: If you unplug the Refrigerator, allow 3 minutes before plugging it back in. The
unit will not restart in less than 3 minutes.
Memorized Temperature Settings
Your unit has been designed to "remember" the last run mode to which it was set. If
there is a power outage or any other power cutoff, the unit will automatically return to
the previous temperature setting after the power has returned.
Compressor Run Indicator
When the compressor is running, the control panel will light a running LED light
representing a running compressor. If the compressor stops running, the running LED
will go out as well.
ALARM Mode
9
Publicité
