Publicité
Noise or vibration
Check that unit is level. If not, adjust leveling legs.
Unit is too warm
Check that door is properly closed and sealed.
Check temperature setting. (To change the temperature setting, follow the steps in
the Operating Your Refrigerator section of this manual.)
Check if door has been opened frequently or recently filled with product.
Unit Develops Condensation on External Surfaces
Check the unit is properly exposed to excessive humidity. Moisture will dissipate as
humidity levels decrease.
Temperature Window displays "EI"
This message is an ALARM MODE indication. It indicates that thermostatic sensor
has malfunctioned. Contact your authorized service facility for sensor replacement.
Temperature Window displays "LI"
This message is an ALARM MODE indication. It indicates that the actual
temperature is much lower than your set temperature.
Temperature Window displays "HI"
This message is an ALARM MODE indication. It indicates that the actual
temperature is much higher than your set temperature. Possible causes are:
The door might not be fully closed.
•
The refrigerant may have leaked.
•
The unit may have been recently loaded with room temperature product.
•
The control panel may not be functioning properly and should be replaced. If
•
you are certain that the door is not the cause of the problem, contact your
authorized service facility immediately.
Manufacturer warrants to the original purchaser at the original site of delivery with
proof of purchase of each Refrigerator that when subject to normal residential use, it is
free from defects in workmanship and material for the periods specified below. This
warranty excludes refrigerators used in rental or commercial applications. It does not
cover labor or labor related charges. There will be shipping and handling charge for
the delivery of the warranty part(s).
Limited Warranty
12
Publicité
