Publicité
Important
When filling the blender jug with hot ingredients, such as when blending a
soup, pay attention to the maximum filling height of the blender jug for hot
contents of 1200ml (marked "hot" / "hot max" on the blender jug). For cold
ingredients, the maximum filling level is 1750ml.
Cleaning
Please always disconnect the device from the power source before cleaning or
moving it. Be careful not to touch the blades with your fingers. NEVER allow
the motor housing to come into contact with water. You clean the stand mixer
as follows:
Cleaning the blender jug
1. Fill the blender jug about 1/4 full with lukewarm water and a few drops of
detergent. Place the blender jug on the motor housing and close it with the
lid. Then let the blender run in the "Clean" program until it is finished.
2. Now rinse the blender jug completely with tap water and then fill it about
3/4 full with warm water (without detergent). Run the blender again in the
"Clean" program until it is finished.
3. If any residual impurities remain, clean the blender jug with a sponge, some
water and detergent. CARE should always be taken when cleaning the
blades and blade assembly.
4. Allow the blender jug to air dry.
Note
This blender and its components are not designed for cleaning in the dishwasher.
The blender jug can be cleaned in the dishwasher up to 100° C max, but using the
integrated cleaning mode is recommended since the cleaning is more thorough.
Cleaning the lid
1. Remove the lid from the mixing bowl.
2. Clean the lid under lukewarm running tap water. Then dry it and reattach it
to the blender jug.
Cleaning the motor housing
1. Unplug the power cord from the wall outlet if you have not already done so.
2. Wipe the outer side of the motor housing with a damp soft cotton or micro-
fiber cloth. NEVER immerse the motor housing under water or other liquids!
3. Make sure that the adjustment wheel moves freely and can be pressed with-
out any problems.
4. Dry the motor housing with a dry soft cloth.
19
Storage
1. First unplug the power cord from the power outlet.
2. Make sure that the blender jug and the lid are clean and dry and that there
are no food residues left. Otherwise, remove them first.
3. Screw the lid onto the blender jug and then remove the blender jug from
the motor housing.
4. Store the appliance in a cool, light-protected and dry place. Ideally, use the
original packaging.
Problem solving
Problem
Possible cause
The blender vibrates more
The blade assembly is loose
than expected, although the
or damaged
blender jug is placed
correctly on the motor
housing
The blender does not turn
The device is not connected
on
to the power source
The overheating protection
of the motor has provided a
shutdown of the blender
The blades no longer rotate
The blade assembly is
defective
The blade assembly is loose
Loud noises can be heard
or damaged
from the vicinity of the
blades
An air bubble has formed
The blender does not
manage to grind the
ingredients
There is too little liquid in the
blender jug
Large, hard ingredients at
the bottom, in the blender
jug cannot be chopped up
Solution
Check whether the blade
assembly is tight and
whether there is any
damage. If the blade
assembly is loose, tighten it
again
Insert the power plug into a
suitable power outlet
Allow the blender to cool for
about 45 minutes before
operating it again. It may
help to cool the bottom of
the motor housing with a
fan
Contact the KLAMER
Support Team
Check whether the blade
assembly is tight and
whether there is any
damage. If the blade
assembly is loose, tighten it
again
Use the plunger to stir the
contents of the mixing bowl
Top up with liquid if
necessary (the blade
assembly should be
sufficiently covered) and
chop the ingredients
20
Publicité
