Publicité
Television and Audio Suggestions
Although all Kriëger
signal interference, some interference with your television picture may be
unavoidable, especially in weak signal areas.
However, here are some suggestions that may improve reception:
1. First, make sure that the television antenna produces a clear signal
under normal operating conditions. Also, ensure that the antenna
cable is properly shielded and of good quality.
2. Change the positions of the inverter, antenna cables and TV power
cord.
3. Isolate the TV, its power cord and antenna cables from the 12 volt
power source by running an extension cord from the inverter to the
television set.
4. Coil the television power cord and the input cables running from the
12 volt power source to the inverter.
5. Attach a "Ferrite Data Line Filter" to the television power cord. More
than one filter may be required. These filters are available at most
electronic supply stores.
Note:
Some inexpensive audio systems may produce a slight "buzzing" sound
when operated with the inverter. The only solution to this problem is to
use a sound system with better power supply filtering.
Operating a Microwave oven with Your Power Inverter
The power rating used with microwave ovens is the "cooking power"
which means the power being "delivered" to the food being cooked. The
actual operating power rating is listed on the back of the microwave. If
the operating power cannot be found on the back of the microwave,
check the owner's manual or contact the manufacturer.
®
inverters are shielded and filtered to minimize
Publicité
