Publicité
CAUTIONS
:
•
Loose connections can result in a severe decrease in voltage that
can cause damage to cables and insulation.
•
Failure to make correct polarity ( Pos, Neg ) connection between the
inverter and the battery bank can result in blowing fuses in the
inverter and can permanently damage the inverter. Damage caused
by reversed polarity is not covered under the Kriëger
•
Making the connection to the Positive terminal may cause a spark as
a result of current flowing to charge capacitors within the inverter.
This is a normal occurrence.
•
Because of the possibility of sparking, however, it is extremely
important that both the inverter and the 12 volt battery be positioned
far from any possible source of flammable fumes or gases. Failure to
heed this warning could result in fire or explosion.
•
Operating the inverter without correctly grounding the unit may result
in electrical shock.
Mounting the Inverter
®
Your Kriëger
vehicle.
If installing in a vehicle, choose a dry, cool, ventilated area closest to the
battery as practical. Before drilling any mounting holes, make sure that
there are no wires, fuel lines, or tanks directly behind the surface to be
drilled. To mount the inverter:
1. Inverter must be OFF.
2. The inverter should be mounted horizontally.
3. Position the inverter against the mounting surface and mark
locations of the mounting screw openings.
4. Remove the inverter and drill four mounting holes.
5. Fasten the inverter to the mounting surface using corrosion-resistant
fasteners sized #10 or larger.
Inverter should not be mounted under the hood of a
®
warranty.
Publicité
