Publicité
Align the appliance using the screw-on feet and a level in such a way
that the roller and the side columns are level with each other. For
this purpose, the screw-on feet can be unscrewed up to a maximum
of 2 1/2" (60 mm).
After leveling the appliance, secure the screw-on feet with the nuts
so they cannot come loose.
Floor anchoring
Suitable anchoring materials for the Rotary Iron are available as op-
tional accessories from Miele Customer Service. Alternatively, the
tensioning strips that secured the Rotary Iron to the transport pallet
for delivery may be used to anchor the appliance to the floor.
1 9/16"
(40 mm)
13/16"
(20 mm)
Tensioning strip from the transport pallet
Coin-operated rotary irons must be anchored to the floor by the
supporting feet to prevent the risk of the machine tipping.
Electrical connection
The electrical connection must be carried out by a qualified electri-
cian who must ensure that all electrical work is completed in accor-
dance with applicable regulations and standards.
A power cord is not included with the machine. Please ensure that a
power cord is available for installation.
The electrical connection and the wiring diagram are located behind
the mounting flap of the right side column.
If the appliance is hard wired, an appropriate sized circuit breaker
must be installed on site. Switches with a minimum contact gap
greater than 1/8" (3 mm) are suitable disconnectors.
The plug connector or disconnector must be easily accessible at all
times.
If the Rotary Iron is disconnected from the electricity supply, the dis-
connector must be lockable or the point of disconnection must be
within clear view of the appliance.
If it is necessary to install a residual-current device (RCD) in accor-
dance with the local regulations, a type-A residual-current device can
be used.
en - Installation and planning notes
3
Publicité
