Emergency Stop; Emergency Lowering - Handicare MiniLift200 Manuel D'utilisation

Emergency stop

To activate the emergency stop
Press the red emergency stop button on the control box.
Resetting
Turn the button in the direction of the arrows until the button pops
out.
To prevent battery discharge, we recommend that the emergency-
stop button is pressed in when the lift is not in use.

Emergency lowering

Manual emergency lowering
For manual emergency lowering, turn the round plastic knob on the
actuator clockwise.
Electrical emergency lowering
For electrical emergency lowering, use the down button on the
control box. Use a narrow object such as a pen.
Instructions for use
These instructions must be followed for correct use of MiniLift200.
Hand control functions
The hand control has four functions: up and down (lift arm), out and in (base width).
Two functions cannot be used at the same time.
NOTE: The hand control functions do not operate if the emergency stop button is activated
NOTE: MiniLift200 may only be used for short transfers. It is not intended for transporting users.
Caution Never move the lift by pulling on the actuator.
Caution Ensure that the user's feet do not get caught between the footplate and the floor. Ensure that the user's feet do
not get caught between the footplate and the base when adjusting the base width.
SystemRoMedic
U S E R M A N U A L
TM
Manual emergency
lowering
Electrical emergency
lowering
9