Intermatic Grasslin thermio essential H Brf Mode D'emploi page 63

4. Press the top button (Fig. 1/4) to increase the value or the bottom button (Fig. 1/7) to decrease the
value.
5. Press the radio communication button (Fig. 1/11) to save the room code or wait five seconds until
the display switches to the current temperature.
Setting up the DIP switch on the actuator (receiver)
1. Remove the cover (Fig. 2/4) of the DIP switch and set the DIP switch (Fig. 2/2).
ð
When setting the DIP switch position, note the room code table (Fig. 10).
2. Replace the cover (Fig. 2/4) of the DIP switch.
The room code that can be set on the room thermostat is in the range 00 –
16 and must match the DIP switch setting on the actuator.
The same room code must be set on the room thermostat and the
actuator.
EN
63