On-Wall Mounting - Intermatic Grasslin thermio essential H Brf Mode D'emploi

Closing the housing
5. Place the housing cover on the housing base and tighten the screw on the device housing with the
Phillips screwdriver.

ON-WALL MOUNTING

Personal:
• Qualified electrician
Removing the housing cover
1. Undo the screw on the device housing with the Phillips screwdriver and remove the housing cover.
2. Mark the hole pattern from the housing base onto the wall and drill holes at the points you marked
(5 mm diameter and at least 25 mm deep).
3. Insert the wall-plugs provided into the holes.
Installing the housing base
4. Fasten the housing base to the wall-plugs with the screws (3.5 x 25 mm) (Fig. 5).
EN
51