Publicité
START/PAUSE button to start the machine, and then press the
START/PAUSE button for 2 seconds. The machine enters the
cleaning function, and the four lights flash alternately. Do not
disconnect the power supply during cleaning. After cleaning, the
machine will automatically enter the standby mode.
3. AJOUTER DE L'EAU: water shortage alarm: when the light
is on, it means water shortage in the water tank. You need to
add water and press the START/PAUSE button to restart the
machine.
4. BAC PLEIN: ice full alarm. When the ice reaches the
maximum amount of ice storage container, the "IBAC PLEIN"
indicator light is on and the machine stops. At this time, the
ice needs to be poured out. When the ice position is lower
than the full sensor position, the machine will restart
automatically.
OPERATING INSTRUCTIONS
Step 1
Open the lid and take out the ice collecting tray and add water to the
reservoir.
Note: There is a maximum scale MAX in the reservoir. The water
should not exceed the MAX position. If the water exceeds the
maximum scale MAX, you need to open the bottom drain plug,
release the excess water, and cover with a transparent cover.
Step 2
Plug in power, press the START/PAUSE button to start the machine.
1. The three cycles used for the first time, the ice produced is small
and irregular.
2. When the ice collecting tray is full, please take out the ice
23
Publicité
