Publicité
There is interior
moisture
The room is humid
A humid environment contributes to moisture buildup.
buildup
....................................................................................................
NOTE: Some moisture
The door(s) are opened often or not
Allows humid air to enter the refrigerator. Minimize door
closed completely,
openings and close doors completely.
buildup is normal
The door is blocked open
Move food packages away from door.
A bin or shelf is in the way
Push bin or shelf back into the correct position.
Storing liquid in open containers
This adds humidity to the refrigerator interior. Keep all
containers tightly covered.
There is frost/ice
buildup in
The drawer is opened often or left
Minimize drawer openings and close drawer completely after
the freezer compartment
open.
use.
Poor door seal
Ensure door seals are making full contact with the
refrigerator cabinet to allow for an adequate seal.
Temperature controls are not set
See "Using the Control(s)" for recommended
temperature
correctly
settings.
Ice and
Water
The ice maker is not
The refrigerator is not connected to a
Connect refrigerator to water supply and turn water shutoff
producing
ice or is not
water supply or the water supply shutoff
valve fully open.
producing
enough ice
valve is not turned on.
There is a kink in the water source line.
A kink in the line can reduce water flow. Straighten the water
source line.
The ice maker is not turned on.
Make sure the ice maker is on. See "Ice Maker and
Ice Storage Bin."
The refrigerator has just been installed.
Wait 24 hours after ice maker installation for ice production to
begin. Wait 3 days for full ice production.
The refrigerator door is not closed
Close the door firmly. If it does not close completely, see "The
completely,
doors will not close completely."
A large amount of ice was recently
Allow sufficient time for ice maker to produce more ice. See
removed.
"Ice Maker and Ice Storage Bin" for ice production rates.
An ice cube is jammed in the ice maker
Remove ice from the ejector arm with a plastic utensil.
ejector arm.
A water filter is installed on the
Remove the water filter and operate the ice maker. If ice
refrigerator,
volume improves, then the filter may be clogged or incorrectly
installed. Replace filter or reinstall it correctly.
A reverse osmosis water filtration system
This can decrease water pressure. See "Water Supply
is connected
to your cold water supply.
Requirements."
The ice cubes are
The water shutoff valve is not fully open.
Turn the water shutoff valve fully open.
hollow or small
NOTE: This is an
There is a kink in the water source line.
A kink in the line can reduce water flow. Straighten the water
indication of low water
source line.
pressure.
A water filter is installed on the
Remove filter and operate ice maker. If ice quality improves,
refrigerator,
then the filter may be clogged or incorrectly installed. Replace
filter or reinstall it correctly.
A reverse osmosis water filtration system
This can decrease water pressure. See "Water Supply
is connected
to your cold water supply.
Requirements."
Questions remain regarding water
Call a licensed, qualified plumber.
pressure.
34
Publicité
