Publicité
OPERATION
release the cutter.
2. Move the handle towards the front of the lawnmower to lower the blade, and
towards the rear of the lawnmower to raise the blade.
3. When desired height is set, release the handle to lock the height adjuster in
place.
Changing The Blade
WARNING! Disconnect the tool from power before doing this or any other
maintenance.
Removal
1. Lay the lawnmower on its side.
2. Wearing thick gloves, grip the blade with one hand.
3. With the spanner provided, undo the blade bolt by turning it counter-clockwise.
4. Remove the blade.
Re-Assembly
1. Wearing thick gloves, grip the new blade with one hand.
2. Place the blade over the blade housing making sure that the two holes on the
blade are securely located over the 2 lugs on the blade housing.
3. Using the spanner provided, replace blade bolt and tighten by turning clockwise.
NOTE: The blade included with this tool is considered as a consumable and
therefore is not covered under warranty. To obtain a replacement blade, contact your
retailer or call us at 1-888-267-7713.
MAINTENANCE
WARNING: Before performing any maintenance, disconnect the lawnmower from
power.
-
Make sure that all nuts, bolts and screws are kept tight and secure.
-
Always have any damaged or worn parts repaired or replaced.
-
Check the blade and the engine mounting bolts at regular intervals.
-
The front and rear wheel spindles should be lubricated periodically with light
lubricating oil.
-
Always have your lawnmower inspected and maintained by a qualified service
facility.
-
The motor and its components should be regularly serviced by qualified
personnel.
-
Ensure that only replacement blades of the right type are used.
-
Frequently inspect the grass collection bag for wear. Replace if worn.
WARNING! Garden chemicals and fertilizers contain agents that accelerate
corrosion in metals. If you are using this tool near where any of those chemicals
or fertilizers have been used, immediately clean the tool after use. All exposed parts
of the tool should be wiped down with a damp (not wet) cloth. When cleaning, never
immerse in water or spray down with a hose. Lubrication is allowed only on metal
parts and only with a light petroleum based oil.
Cleaning
-
To ensure the best performance from the lawnmower, it is important to keep it
clean.
-
Always clean the lawnmower immediately after use.
-
Do not allow grass cuttings and other debris to become dry and hard on any of
the lawnmower surfaces. This will directly affect the cutting and grass collection
7
Publicité
