Publicité
OPERATION
WARNING: Before switching the lawnmower on, ensure that the grass
collection bag as been correctly assembled according to the instructions above.
WARNING: Ensure that the work area is clear of stones, sticks, wires, or
anything else that could interfere with the operation of the lawnmower.
WARNING: While using the lawnmower, keep all bystanders and animals at a
minimum of 5 meters away at all times.
On/Off Switch
1. Plug the mower into a 120V, 60Hz, 13A power supply.
2. Using your left hand, press and hold the safety lock-off button on the switch
assembly.
3. While holding the safety lock-off button, squeeze the switch lever with your right
hand. The motor will now start.
4. Continue to hold the switch lever and release the safety lock-off button.
WARNING: Always operate the lawnmower with 2 hands. Never attempt 1
handed use.
5. To stop the lawnmower, release the switch lever.
6. Unplug from power supply.
WARNING: The blade will continue for a few seconds after the lever has been
released. Allow the blade to stop moving completely and unplug from power
supply immediately after use.
Using The Lawnmower
Always observe the strictest safety procedures when using the lawnmower.
Carefully read the safety instructions of this manual before using.
Maintain the sharpness of the blade when cutting grass. If the blade has worn
excessively and become pitted and blunt, it should be replaced or sharpened. When
the blade is sharpened the balance of the blade must be maintained. Blade
sharpening should only be undertaken by qualified service personnel. The
sharpness of the blade will directly affect the performance of the lawnmower.
The best results will be achieved if the grass is dry. Wet grass will tend to clog the
blade and the grass collection system. Grass grows at different rates at different
times of the year. Never use the lowest cutting height for the first cut of the season
or in drought conditions. Only about one third of the grass height should be cut. If
the grass to be cut is over six inches tall, use the highest cutting height. Then mow
at a lower setting for the best results.
If the lawnmower will not collect the cuttings efficiently, the grass discharge chute
may be blocked, the grass box may be full, or the underside of the mower deck may
be clogged.
Do not attempt to remove grass from the grass chute area while the blade is
rotating. Before clearing any blockages, or emptying the grass box, make sure that
the motor is switched off and disconnected from the power supply. The blade will
continue to rotate for a few seconds after the engine has stopped.
Cutting Height
This edger has 8 adjustable height settings:
25, 32, 39, 46, 53, 60, 67, and 75 mm
(1", 1.25", 1.5", 1.8", 2.1", 2.35", 2.6", and 2.95")
1. Grasp the height adjustment handle and squeeze the 2 pieces together to
6
Publicité
