Publicité
1
ASSEMBLY INSTRUCTIONS
Handle Assembly
Lower Handle
1. Remove the 2 screws located in the handle holes that are fitted to the top of the
deck.
2. Insert the lower handle pieces so the square holes are oriented towards the
outside of the mower.
. Replace the screws removed in step 1 and tighten so the lower handles are
fixed in place.
Upper Handle
1. Attach the upper handle so that the On/Off switch is located on the right side of
the lawnmower when viewing from behind.
2. Fasten by fitting the square bolts from the outside and tighten with the threaded
knob on the inside.
3. Use the cable grip to route the cable from the switch to the motor neatly against
the handle.
4. Pass a loop of the power cable through the cable restraint and wrap around the
inner square. Repeat with the extension cord so that there is no strain on the
connection.
Grass Collection Bag
1. Slide the metal frame inside the grass collection bag as shown below. (fig.1)
2. Clips are fitted to the grass collection bag that fit over the frame as shown
below.
3. Attach the grass collection bag assembly to the lawnmower so the 2 lugs on the
frame are fitted over the hooks in the deck. When properly assembled, the grass
discharge flap should lay flat on top of the collection bag.(fig.2)
2
3
FIG1
1
2
FIG2
5
Publicité
