Publicité
2. SPECIFICATIONS
Auto Ribbon Saving Mode
Auto ribbon saving function is activated when it is selected by DIP switch (Refer to page 4-1) and
none print area extends for more than 20 mm.
NOTES: 1. To activate ribbon saving function at a speed of 8"/sec., the no print area should extend
more than 25 mm.
2. Depending on the relationship between the outer diameter of rewound ribbon and print
speed, ribbon usage may vary as follows:
Print speed
3. For the B-882, contact your authorised TOSHIBA TEC representative to change the
Operation Panel setting.
2.2 OPTION
Option Name
Cutter module
High speed PC
interface kit
(B-872 only)
Strip module
D-RAM PC Board
(B-872 only)
Flash memory card
(B-872 only)
PCMCIA interface
board
(B-882 only)
NOTES:1. Available from your nearest TOSHIBA TEC representative or TOSHIBA TEC Head
Quarters.
2. Available from TOSHIBA TEC Parts Center.
3. When purchasing flash memory card locally, select one having the specifications described
at page 9-1.
Ribbon loss
3"/sec
Approx. 5 mm
4"/sec
Approx. 10 mm
8"/sec
Approx. 23 mm
Type
B-4208-QM
A stop and cut swing cutter
B-4800-PC-QM
This interface kit allows extremely high speed
information transfer between the printer and
PC.
B-4908-H-QM
This module strips the label from the backing
paper with the take-up block and strip block.
FMBC0067801
A 2MB RAM upgrade which enhances the
image handling capability of the printer.
A flash memory card (1MB and 4MB) for stor-
ing logos, writable characters and formats.
B-8700-PC-QM
This board enables the following PCMCIA cards
to be used.
* LAN card: 3 COM EtherLink
* ATA card: Conforming to PC card ATA stan-
* Flash memory card: 4MB card
1.)
Description
mended)
dard
E2-2
ENGLISH VERSION EO1-33018
Source
See NOTE 1.
See NOTE 1.
See NOTE 1.
See NOTE 2.
See NOTE 3.
See NOTE 1.
®
III (recom-
(See Page 10-
2.2 OPTION
Publicité
