Publicité
8. LOADING THE MEDIA
Strip type:
1
Strip labels from the backing paper for about 200-mm long from the top edge of the label roll.
2
Lower the backing paper release bar.
3
Pass the backing paper between the strip roller and the backing paper holder. After taking up
any slack of the media, set the backing paper release bar in position.
Media (Backing Paper)
Backing Paper Release Bar
9. Turn the head lever to the proper position depending on the used media. (Refer to Fig. 7-1)
1: Labels or thin tag paper
2: Thick tag paper
CAUTION: When using labels ensure that the head lever is set to position 1 .
10. Close the top and right side covers.
Backing Paper Holder
E8-5
ENGLISH VERSION EO1-33018
8. LOADING THE MEDIA
Fig. 8-8
Publicité
