Before Starting - Royal RCG 3,6 Li Mode D'emploi D'origine

Anleitung_RCG_3_6_Li_SPK7:_
Battery charger
Mains voltage
Output
Rated voltage
Rated current:
Sound and vibration were measured in accordance
with EN ISO 3744.
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.

5. Before starting

5.1 Charging the battery pack (Figure 1, 3)
Connect the charger to the charging station
(Figure 5).
Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the battery charger in a socket-
outlet. The red LED (Figure 5 / Item 1) comes on
to indicate that charging voltage is available.
The battery pack is being charged. An empty
battery pack requires a maximum charging period
of 3 to 5 hours. The temperature of the battery
pack may rise slightly during the charging
operation. This is normal.
03.04.2012 15:49 Uhr
As soon as battery pack is fully charged, the red
LED (Fig. 5/Item 1) extinguishes
230-240 V ~ 50 Hz
If the rechargeable battery fails to charge, check
whether there is voltage at the socket outlet.
Timely recharging of the battery pack will help it
6 V DC
serve you well for a long time. Recharging is always
necessary when you notice a drop in the toolʼs
300 mA
performance.
Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.
5.2 Fitting the long handle
Using the telescopic long handle (Fig. 1/Item 5) you
can push the cordless shears on wheels over the
lawn.
To fit the long handle, push the mount (Fig. 3a/Item 8)
onto the long handle until the lock engages in one of
the recesses on the mount. The equipment is
provided with one recess at the top for standard
cutting and two recesses on the left and right for
cutting edges. Now pass the wheels (Fig. 3b/Item 2)
through the axle mount and plug together.
Undo the clamp coupling (Fig. 1/Item 6), adjust the
telescopic handle to the required length and then re-
tighten the clamp coupling again. Now push the
equipment in the direction indicated by the arrow into
the mount (Fig. 4a/Item 8) as shown in Figure 4a.
Ensure that the mount locks into the recesses
correctly. Then connect the power plug (Fig. 4b/Item
1) to the equipment as shown in Figure 4b. To
disassemble, proceed in reverse order.
Important!
It is prohibited to remove or bridge any of the
switching elements installed on the tool by the
manufacturer (e.g. by securing a button to the
handle) as this would prevent the tool from
switching off automatically and result in high risk
of injury.
Under no circumstances are you to use the shrub
cutter with the telescopic long handle fitted.
Seite 11
GB
11