Publicité
Step 21
å
Before fastening the DOOR to your unit, be sure the
mounting screw is against the stops as shown in the
right diagram. If it isn't, loosen the adjusting screw
and mounting screw to slide it against the stops. Then
tighten the mounting screw.
å
Fasten one DOOR (K) to the LEFT END (B) as shown in
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
å
Fasten one PULL (191K) to the DOOR (K). Use two
BLACK 7/8" MACHINE SCREWS (37S).
å
Repeat this step for the other DOOR (K).
å
See the next step for DOOR adjustments.
37S
BLACK 7/8" MACHINE SCREW
(4 used for the PULLS)
www.sauder.com/service
K
191K
433964
B
K
191K
17
Stop
Mounting
screw
Adjusting
screw
Hinge
Page 25
Publicité
