Publicité
Step 17
å
Carefully turn your unit over onto its front edges.
å
Fasten the BASE (J) to the METAL BRACKETS on the
ENDS (A and B) and BOTTOM (H). Use five BLACK 9/16"
LARGE HEAD SCREWS (1S).
å
NOTE: You should start each SCREW a few turns before
completely tightening any of them.
å
NOTE: The BASE should be centered on your unit.
The top surface of the BASE
should be even with the top
surface of the BOTTOM.
BLACK 9/16" LARGE HEAD SCREW
(5 used in this step)
www.sauder.com/service
A
H
J
1S
B
For support, place packing
material or books here.
Angled edge
433964
Page 21
Publicité
