Publicité
Step 18
å
Unfold the BACK (BK1) and lay it over your unit.
å
A perforation in the BACK (BK1) has been provided for access to the SAFETY STRAP. Punch out the perforation for the
SAFETY STRAP attachment later in assembly.
å
IMPORTANT: Your unit must be "squared up" to the BACK (BK1) before fastening. Make equal spacing along all four edges
of the BACK (BK1). Push on opposite corners of your unit if needed to make it "square".
å
BACK INSTALLATION:
1.
Begin fastening the BACK (BK1) using four BLACK 9/16" EURO SCREWS (62S) through the four holes shown at positions 1.
2.
Finish fastening the BACK (BK1) to your unit using the NAILS (1N) through all remaining holes.
3.
NOTE: Be sure to tap NAILS into the holes that line up over the FIXED SHELF (E) and UPRIGHT (F).
NAIL
(69 used in this step)
1
Page 22
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
BLACK 9/16" EURO SCREW
(4 used in this step)
1N
1
62S
These holes must line up
over the FIXED SHELF (E)
1
and UPRIGHT (F).
BK1
433964
8
Before fastening
the BACK, punch
out the perforation.
1
www.sauder.com/service
Publicité
