Publicité
Required accessories and tools
Supplied accessories
—
Installation instructions
-—
Operating instructions
—
Installation kit
Optional accessories
Extreme Combination Side-by-Side Heating kit
if the gap between the appliances is less than 6" (160 mm).
Other required accessories from
specialist outlets
Ice maker installation kit 17," OD copper line
For connecting appliances which require water, e.g. for an
ice maker.
Maximum outer diameter of the water pipe
(without fittings):
S/30" (10 mm).
Tools
-
Cordless screwdriver T20
-—
Torx screwdriver T20
-
Torx bit T20 + magnetic holder
—
7/46" (8 mm) hex nut driver
-
Wood drills in different sizes
—
Open end wrench '/5" (SW 13 mm)
—
Multigrip pliers
-
Adjustable wrench
-—
Cutter with adjustable blade
—
Metal tape measure
-
Square
-
Spirit level length 2' (60 cm) and 4' (1,2 m)
-
Marking-out level, length at least 4' (1.2 m) for individual
appliances or 7' (2.0 m) for Side-by-Side installation
10
Other
Stepladder
Dolly, hand truck
Hammer drill for drilling holes in wail or floor
Bits according suitable for material and in different sizes
Wooden beam (cross section min. 3" x 4"
(75 x 100 mm?) as an alternative tilt protection,
length according to the width of the installation cavity
Wooden screws in different sizes
Thin (max. '/;¢" (1.5 mm)), suitable material to protect
the floor from damage (e.g. lino)
Suitable materia! for covering and protecting furniture
(e.g. protective sheets)
Adhesive tape
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
Publicité
