Publicité
10.
Removing stainless steel front panel
from the freezer compartment
drawer
m
Loosen and unscrew nuts on the top of the door.
However, do not turn the threaded bolts, otherwise
the door will no longer be aligned.
m
Do not loosen the screws on the left and right fixing
brackets. Do not unscrew the screws!
11.
Aligning the appliance
CAUTION
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
—
Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
—
The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
—
lf using a wooden beam as an alternative anti-tio
device according to point 6 of this installation
manual, rotate the appliance all the way towards the
wooden beam.
>
m
Pull the bottom of the stainless steel front panel away
from the door to remove the fixing brackets from the
screws. Then lift the door off the threaded bolts.
m
Place fixing brackets only loosely into the plates.
Ensure that you do not lose them.
m
Remove base panel from the appliance.
m =
Align the appliance with the furniture fronts.
The height-acjustable feet at the front and rear can all be
adjusted from the front.
Front:
with open-ended wrench 1/5" (SW13)
Rear:
with °/,," (8 mm) hex nut driver via flexible shaft.
A mark is attached to the appliance base and is used as a
standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1 1/4" (82 mm) above the
floor.
17
Publicité
