Publicité
As shown in the figure above, use screws to combine D1, D2,
D3, and E1, E2, E3,and connect the two support rods U1.U2
to the base S and the down tube Y respectively. Pay attention
to the up and down direction of the support rods.
10
1.Fix the middle tube X and
the lower tube Y with two
screws F and tighten them.
2.Use wheel pin 0 to pass
through wheel G,base S and
down tube Y in turn,as
shown on the left.
As shown in the figure, use the screw combination B1 and B4
to connect the basket ring J.the backboard M and the
horn-shaped bracket K. Note that the two spring screw
combinations B4, B5, B6, B7 must be connected to the two
above the ring hole.
As shown in the figure, use the screw combination C1, C2 to
fix the upper end of the basketball backboard bracket K
behind the backboard M, and tighten the screws.
11
Publicité
