Publicité
Use safety instructions
In order to ensure safety, the user must read the instructions
carefully before installation and use, and install, use, store,
move and disassemble in accordance with the instructions.The
user should check the solidity of the counterweight screws of
the base before use to avoid damage to the product. And any
damage to the user.
1.It is recommended that 2 or more adults install it, and children
are not allowed to install and climb.
2.Before use, check whether the base is leaking and whether the
screws are tight. A small flow of water may cause the product to
collapse.
3.The product is only for recreation and fitness, not for fierce
competition.It is forbidden to dunk or hang on the hoop vigorously.
4.After installation, the base needs to be filled with water or sand
to prevent from collapsing. The base must be placed flat on a
level ground to keep sturdy and avoid being damaged by sharp
objects during use.
1.It is forbidden to climb or hang on the hoop, backboard bracket
and bead net.
2.If there are parts that need to be repaired or replaced please
contact after-sales personnel or local deal dealers in time.
3.Special care must be taken when moving on uneven ground to
avoid product scratches or tip over.
4.In order to avoid damage to the base due to freezing when the
temperature is lower than 0 degrees Celsius, the water in the
base must be poured out or filled with sand.
5.If the product is used outdoors for a long time, please ensure
that the top of the main pole and the lifting pole are covered with
plastic covers to prevent rainwater from affecting the product's life.
6.It is not recommended to wear watches, necklaces earrings or
other jewelry when playing to avoid losing during exercise.
7.Keep your fingers away from the moving parts when adjusting
the height for safety.
8.It is forbidden for children to move the product or
adjust the height of the product.
06
Warning:
Height adjustment
As shown in the figure, use screw F to adjust the product to the
required height.
Parts List
Accessory
Name
model
A
Plastic screw
B1.B2.B3
Screw ,M8 X35MM
B4.B5.B6.
Screw with spring,
B7
M8 X 110MM
C1.C2
Screw,M8 X16MM
D1.D2.D3
Screw ,M8 X 20MM
E1.E2.E3
Screw,M8 X 90MM
F1.F2.F3 Screw ,M10X85MM
Quantity
Note
Connect top pole and middle
2
pole
Connect backboard,hoop and
2
backboard bracket
Connect backboard,hoop and
2
backboard bracket
Fix the backboard bracket to
2
the backboard
Connect the base and base
2
support rod
Connect top pole and middle
1
pole
Connect the backboard bracket
and the top pole
5
Connect the base and base
support rod
07
Publicité
