Publicité
• T BLADE TRIMMER (E): Suitable for trimming hair, beards, moustaches and
sideburns. It can be used with or without a guide comb J, K or L, depending on the
desired cutting height.
• SHAVER HEAD (F): Suitable for shaving.
• NOSE AND EAR TRIMMER (G): Suitable for trimming hair from the nose and ears.
IMPORTANT: do not insert it more than 5 mm inside the nose or ears. Slowly move
in and out while the trimmer revolves to remove the unwanted hair. For improved
results, ensure that the end of the trimming head touches the skin. This will reduce
the tickling sensation that can be caused by nasal hair.
• EYEBROW TRIMMER (I): Suitable for trimming moustache, sideburn and
eyebrows. It can be used with or without guide comb "H" depending on the desired
cutting height.
INSERTION OF A COMB GUIDE (FIG. 4)
• Fit the comb guide to the appliance.
• Grasp the comb guide by both ends. Insert the upper part of the head into the
guide's teeth and press the rest of the body down until it is firmly in place.
• To remove the guide comb, pull upward from the lower part of the comb guide.
USE
• The appliance can be used directly connected to the mains or by using its batteries.
• Extend the supply cord completely before plugging it in.
• Connect the appliance to the mains.
• Make sure that the blades are correctly aligned.
• Turn the appliance on by using the On/Off button.
• The appliance gives you the choice of trimming or shaving.
COMB TO TRIM BEARD
• For a three-day beard, use the 3 mm measurement guide comb. (J).
TO TRIM
• Use the guide combs (I, J, K, L) depending on the desired cutting length.
Publicité
