Selecting The Input Source; Selecting The Color System - Sony MV-900SDS Mode D'emploi

Selecting the input source

You can select the input source for the
monitor.
DISPLAY
1
4
7
TOP MENU
MENU
VOL
1
Press (POWER) to turn on the player.
The current input source (DVD) appears on
the screen for 5 seconds.
2
Press (INPUT) repeatedly to select the
input source.
Each time you press (INPUT), the indication
changes as follows:
DVD y VIDEO
Be sure to change the input source setting
to "DVD" to play a disc or "Memory Stick"
with this player.
Note
When you play a "Memory Stick," set the input
source to "DVD."
Tip
If your car has no ACC (accessory) position on the
ignition key switch and you set the POWER SELECT
switch to the B position, the player does not turn
on by pressing (POWER) on the card remote
commander (page 6).
14
POWER
POWER
SEARCH
2 3
CLEAR
5 6
8 9 0
SUBTITLE
ANGLE
ENTER
AUDIO
INPUT
SETUP
INPUT

Selecting the color system

The player detects the color system of the
input video signal (NTSC or PAL) and changes
the setting automatically (auto mode).
Do the steps below to change the color system
setting for the input video signal manually.
POWER VOL +/–
1
Press (POWER) to turn on the player.
The current input channel (DVD) appears
on the screen for 5 seconds.
2
Within 5 seconds, press (VOL) (+) or
(VOL) (–) repeatedly to select "NTSC" or
"PAL."
Note
When changed manually, color system setting for
the input video signal does not return to auto
mode until the player is turned off or input
channel setting is changed. Therefore, when it is
set to "PAL," the DVD recorded in NTSC system
cannot be viewed on the monitor of the player
unless you turn off the player, then turn it on
again.