Publicité
5
J
E
Install the upper pipe:
As shown in the figure, pull out part of the the inner lifting rod (O)
and put it into the upper tube (W). Use screw (E) to fix the
backboard support brace (J) to the upper tube (W) and the inner
lifting rod (O). Note that the hole of the inner lifting rod (O) is aligned
with the hole below the upper tube (W).
12
W
O
6
E
Install base bracket:
As shown in the figure, insert the upper tube (W) into the middle
tube (X), fix the lower end of the middle tube (X) with the inner lifting
rod (O) with the screw (E), install the handle (P), and then insert the
middle tube (X) into the lower tube (Y) and secure with the screw
(E). Set product to proper height and secure with rotary knob (F).
W
F
P
X
E
Y
13
Publicité
