Publicité
Top support frame
Top duct covers
Bottom duct covers
Bottom support frame
11. *Secure top duct covers (with louver holes) to top support frame using (2) 3/16 x 1/4 screws. (FIG. H, #1). Note: If
using hood in "ducted mode" the top duct covers may be turned upside-down to hide the louver holes.
12. Assemble top duct covers together using (3) M3 x 5 screws on each side. (FIG. H, #2). Larger screw hole openings
should overlap the smaller holes.
13. Assemble bottom duct covers together over top duct covers using (3) M3 x 5 screws on each side. Bottom duct
covers will rest on top of the hood body. (FIG. H, #3)
14. Insert the (2) thin trim pieces into left and right seams of bottom duct covers. (1 on each side)
(FIG. H, #4)
15. Insert the (2) thick trim pieces into left and right seams of top duct covers. (1 on each side) (FIG. H, #5) Note:
Because less of the top duct covers will be exposed, it may be necessary to measure and cut the thick trim
pieces before installing them into the top duct covers.
* If using hood in recirculating mode you must install the air diverter plate before assembling the duct covers.
Turn to page 13 for instructions.
www.zephyronline.com
1
2
5
Thick trim piece (top)
4
Thin trim piece (bottom)
3
FIG. H
12
cut trim piece
if necessary
Publicité
