Publicité
Once the pump is dry, it is ready to be stored safely.
Transportation and Storage
Shaking, crashing and turning the device upside down should be prevented when transporting it. Store
it in a properly ventilated location with dry air and without any corrosive gas.
Store the device in ambient temperatures above zero in a horizontal position. If the pump has been
stored for more than a few days, ensure the device functions properly before installing it again.
Cleaning and Maintenance
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used. Wait for the rotating elements to stop.
Use only non-corrosive cleaners to clean the surface.
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
The device must be regularly inspected to check its technical efficiency and spot any damage.
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or other
chemical substances because it may damage the device.
Clean organic deposits from the device after every use with a stream of clean water and a soft cloth.
Disposing of Used Devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device recycling
and collection point. Check the symbol on the product, instruction manual and packaging. The plastics used to
construct the device can be recycled in accordance with their markings. By choosing to recycle you are making a
significant contribution to the protection of our environment. Contact local authorities for information on your
local recycling facility.
Troubleshooting
Problem
The device does not start
EN
Possible reason
Overcurrent circuit breaker has
tripped
No power
Damaged engine or power cable
Solution
Remedy the cause of the circuit
breaker tripping. Wait for the
motor to cool down. Reset the
circuit breaker to its original
position.
Make sure the power cable is
connected properly.
Call your agent or qualified
technician.
Publicité
