Publicité
the shoulder belts.
REMOVAL OF THE SEAT BELTS
1.
Loosen the belts (see: Belt tension adjustment).
2.
Adjust the headrest to the highest available position (see: Headrest adjustment).
3.
Press the button located on the buckle and unfasten the belts.
4.
Remove the belts from the buckle located at the rear of the backrest (fig. 11), then
put the belts through the holes in the backrest.
5.
Unfasten the upper part of the backrest cover, and pull out the shorter part of the seat
belts with covers, removing them from the hooks located inside the backrest (fig. 12).
6.
Put the seat in the reclining position, then remove the belt from the buckle located in
the base of the seat. Remove the belt along with the buckle and buckle cover (fig. 13).
To reinstall the belt, repeat the above steps in reverse order.
HEADREST ADJUSTMENT
To change the headrest height:
1.
While holding the seat belt tension adjustment button (9, fig. A), loosen the belts.
This will allow you to adjust the height of the headrest more freely.
2.
Pull the headrest adjustment lever and adjust the height of the headrest to the
child's shoulder level (fig. 14).
Note! Make sure the belts are not too high, such as at or above the ear line, or too low,
such as behind the child's back (fig. 15).
SEAT TILT ADJUSTMENT
To adjust the seat tilt, press the seat tilt adjustment lever (10, fig. A) and move the seat to
the desired position (fig. 16). Move the seat slightly until you hear a distinct click sound – the
seat has been secured in the selected position.
Note! In the rearward-facing position, use the seat in the semi-reclining position. In the
forward-facing position, use the seat in one of the available positions 1-2-3.
REMOVING AND ATTACHING THE COVER
Unzip the cover and slide it completely off the seat body. To do this:
1.
Adjust the headrest to the highest available position (see: Headrest adjustment).
2.
Unfasten the seat belts.
3.
Start the removal from the cover located on the headrest.
EN
‑ 16 ‑
Publicité
