Publicité
finger (B, fig. 3).
6.
Make sure that the belt is as tight as possible and that it is not twisted. Make sure
the car belt buckle is not too close to the lap belt guide (fig. 4).
7.
Place the child in the seat (fig. 5) and fasten it with the seat belts (see: Seat belts).
8.
Adjust the headrest (see: Headrest adjustment).
Note! Make sure that the seat belts fit tightly on the child's body and that they are not
twisted. Make sure the lap belts run low and protect the child's pelvis. The belts should be
tight against the child's body, but should not be too tight and cause discomfort.
REARWARD-FACING (100 – 150 CM)
1.
Remove the seat belts (see: Removal of the seat belts) and remove the reduction pad.
2.
Adjust the seat to one of the available positions 1-2-3 (see: Seat tilt adjustment).
3.
Place the car seat on the couch of the car. Make sure the seat fits firmly against
the car seat (fig. 6).
4.
Place the child in the seat and adjust the headrest (see: Headrest adjustment).
5.
Feed the shoulder belt through the green colored space between the headrest and
the seat (A, fig. 7). Pass the lap belt through the lap belt guide (13, fig. A).
6.
Fasten the belt and make sure it is as tight as possible and not twisted. Make sure
the car belt buckle is not too close to the lap belt guide (fig. 7).
REDUCTION PAD AND LUMBAR PAD
The pads are designed for the smallest children, improving their comfort and providing
additional support. The lumbar pad is designed for infants – pull it out when the child
needs more space in the seat. The reduction pad can be used until the child exceeds a
height of 60 cm.
SEAT BELTS
BELT FASTENING
1.
Connect the belt connectors , and then insert them into the buckle (fig. 8). You will
hear a characteristic click. Make sure the belts are properly tensioned and not twisted.
2.
To unfasten the belts, press the red button on the buckle.
BELT TENSION ADJUSTMENT
1.
To tighten the belts, pull the belt tension adjustment strap (fig. 9).
2.
To loosen the belts, press the belt tension adjustment button (fig. 10) and pull on
‑ 15 ‑
EN
Publicité
