Publicité
- The display is now connected.
NB: To connect the display to a socket without any protection wire, or to connect
directly to the electrical system, ask for a qualified electrician to make the
connection.
c) Use of device :
Elements of command and display
Command/Display
Switch (n°1 on the picture)
Electronic thermostat (n°2 on the picture)
Digital switch (n°3 on the picture)
Starting
- Press on the on/off switch (n°1 on picture) to start the unit. The electronic
thermostat (n°2 on picture) turns on.
- Press on the light switch (n°3 on picture) to start the light.
- Wait for the unit to be at the right temperature (stop of the compressor).
Temperature setting
The electronic thermostat is preset in factory. It can be adjusted if necessary.
To modify the temperature, refer to the
thermostat.
Regulation of defrost
The defrost is an important operation for ventilated refrigerating displays like 800
and 1200.
A homogeneous temperature is ensured thanks to the air circulation through the
evaporator. This evaporator has a negative temperature when the compressor is
working. In this way, its blades "trap" the humidity as frost, and the air of the
chamber dries. If there is too much frost, the air cannot circulate through the
evaporator and the internal temperature rises.
In order to avoid this phenomenon, the defrost programmed in the factory stops the
compressor 15min every 2 hours.
These values can be adjusted by your technician. It depends on the type of products
presented in the refrigerating display, on the use and the environment.
Function
Display power
Temperature setting
Light On/Off
technical documentation of the
15
Publicité
