Publicité
CARE INSTRUCTIONS
1/ Your product
Properties
Aluminium is a light, resistant material that doesn't rust.
Cord or acrylic knit is made up of a mix of polyester and polyamide fibres, around an EVA (ethylene-vinyl a
cetate) core, which gives it both flexibility and rigidity. It is hand braided.
Acacia is a hardwearing exotic wood covered with a protective oil.
To begin with it presents a golden brown sheen but it turns to a grey/green tone when exposed to bad wea
ther and UV rays. It nonetheless retains its properties.
Polyester is a synthetic fabric that offers good resistance to tearing and rubbing.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the different parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the different asse
mbled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little geometric differenc
es.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is carried ou
t individually, before assembly. These metallic elements cannot be free from appearance irregularities com
ing both from the surface treatment process and assembly operations. The final appearance of the product
is therefore directly linked to these possible irregularities.
Regularity of seams
Although we pay special attention to the quality and regularity of seams, it is possible to notice that some th
reads are not cut after the break point of the seam. There is no risk of the seam becoming undone. Cut this
thread with a simple pair of scissors.
2/ Precautions for use
Before using this chair for the first time, we recommend that you thoroughly clean the various elements with
a cloth dampened in soapy water, then apply a thin layer of protective oil, allow to dry in the shade before w
iping with a clean cloth excess oil that would not have penetrated the wood. Start again after 48 hours. Ther
e is no need to switch your furniture to sandpaper.
We do not recommend the use of a stain or varnish which forms a surface layer and prevents the wood from
breathing. It is preferable to apply an oil which will deeply impregnate the wood.
Be careful, wood is a living material: it may release tannins during the first days of use. We therefore recom
mend installing the product first directly on the lawn, until the wood no longer releases tannins. If you were
to put it on a hard terrace, be sure to leave wedges under your feet for a few days. If in spite of everything,
tannins come to soil your terrace, get to a specialize store to choose the cleaning product most suited to yo
ur type of terrace. But be aware that it is possible to clean the traces of tannins even on the most porous m
aterials, with a high pressure jet.
Do not put hot objects on the table itself, they will leave permanent marks on it (discoloration, deformation,
cracks...). Always use table mats.
Do not use a plastic tablecloth on the table. Exposed to UV and heat, it would melt and act as a decal, espe
cially on steel, aluminum and glass. This would result in irreparable deterioration of the tray in the form of w
hite streaks. Instead, use a fabric tablecloth.
Watch out for blows from knives and other sharp objects handled nearby. Watch out too for burns from ciga
rettes and from other heat sources.
Publicité
