Publicité
Dear customer,
KS Tools thanks you for your trust and for buying one of its products.
In this manual, you will find every safety warnings and precautions, operating, maintenance and cleaning
procedures. Please, read it carefully before using the product. Keep this manual and invoice in a safe and dry
place for future reference. The manufacturer cannot be held responsible for damage or injury caused by
improper use of this appliance.
PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USE
IMPORTANT
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFETY INSTRUCTIONS N WARNINGS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO
MAY CAUSE DAMAGE TO PROPERTY AND/OR SERIOUS PERSONAL INJURY. PLEASE KEEP THIS INSTRUCTION
MANUAL SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS AND WARNINGS
1.
Use a qualified person to maintain the press in good condition. Keep it clean for best and safest performance.
2.
The maximum load is 20tons. DO NOT exceed this rated capacity. Never apply excessive force to a workpiece and
always use the pressure gauge to accurately determine the applied load.
3.
Use this press for the purpose for which it is intended. DO NOT use it for any other purpose it is not designed to
perform.
4.
Keep children and unauthorized persons away from the work area.
5.
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewelry, and contain long hair.
6.
Wear ANSI approved impact safety goggles, full-face impact safety shield and heavy-duty work gloves when operating
the press.
7.
Keep proper balance and footing, do not overreach and wear nonslip footwear.
8.
Only use this press on a surface that is stable, level, dry and not slippery, and capable of sustaining the load. Keep
the surface clean, tidy and free from unrelated materials and ensure that there is adequate lighting.
9.
Inspect the press before each use. DO NOT use if bent, broken, cracked, leaking or otherwise damaged, any suspect
parts are noted or it has been subjected to a shock load.
10. Check to ensure that all applicable bolts and nuts are firmly tightened.
11. Ensure that workpiece is center-loaded and secure.
12. Keep hands and feet away from bed area at all times.
13. DO NOT use the shop press to compress spring or any other item that could disengage and cause a potential hazard.
Never stand directly in front of loaded press and never leave loaded press unattended.
14. DO NOT operate the press when you are tired or under the influence of alcohol, drugs or any intoxicating medication.
15. DO NOT allow untrained persons to operate the press.
16. DO NOT make any modifications to the press.
17. DO NOT use brake fluid or any other improper fluid and avoid mixing different types of oil when adding hydraulic oil.
Only a good quality hydraulic jack oil can be used.
18. DO NOT expose the press to rain or any other kind of bad weather.
19. If the press need repairing and/or there are any parts that need to be replaced, have it repaired by authorized
technicians and only use the replacement parts supplied by the manufacturer.
20. WARNING: the warnings, cautions and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the operator.
EN: Original version of the manual
Publicité
