Publicité
EN
For mounting the panels follow these instructions
-
Before driving the nails, we strongly recommend drilling the board with a drill bit
the hole in size 2,5mm.
-
Painting all exposed nail heads is recommended.
-
Drive the nails from the center of the panel towards the ends or from one end to
another end. NEVER START hammer nails from the ends towards the middle.
-
Do not overdrive nails. The nail head should sit snug to face of siding but not be
overdriven to distort the siding surface.
To install the OSB plates, it is essential that the rest of the structure is straight and level.
Make sure that the walls are level, that the gables are vertical and that the rest of the
structure is straight. Before installing the OSB panels, we recommend checking
whether the diagonals of the roof are the same length. To install the OSB plates,
position them so that they do not exceed the ridge purlin.
-
The roof load cannot exceed 120 kg/m²!!!
Install the drip edge to the back and both sides of roof panels before installing
bituminous cover. Only after you complete the installation of bituminous cover, attach
the last drip edge over the top of bituminous cover.
OSB ROOF
DRIP EDGE
Publicité
