Publicité
Remove from below the vehicle any protective sealant from the points of contact between the shell and the tow bar; then paint the
uncovered parts with rust preventer.
1.
Disassemble the lights and the rear bumper.
2.
Disassemble the reinforcement cross bar, the heat guard plate and eliminate the towing ring.
3.
Unfasten the exhaust pipe and disassemble the spare wheel (if present).
4.
Place towbar "A" on the spars inner side in correspondence to holes "01" and "02", interject the wide washers and then fix.
5.
Tighten all bolts and nuts with a tightening torque as shown in the enclosed layout.
6.
Connect the wiring to the socket (usually given apart), following the car booklet's instructions "use and maintenance" as
shown in the enclosed wiring kit layout.
7.
Make a cut on the heat guard plate and on the inner brackets of the reinforcement cross bar as shown in the enclosed
layouts.
8.
Reassemble the heat guard plate.
9.
Reassemble the exhaust pipe and the spare wheel (if present).
10.
Reassemble the reinforcement cross bar.
11.
Reassemble the lights and the rear bumper.
INVISIBLE AND SWIVELING SOCKETHOLDER FOR MODEL "C" AND "VM"
•
Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify also that the vehicle's towing
disposal quoted on the car registration is mentioned on the tow bar document. Otherwise ask for the appropriate office
(umbrarimorchi@umbrarimorchi.it) for explanations or updated documents.
•
For safety, all work involving tow bar installation must be undertaken by skilled technicians.
•
Damaged components must be replaced with manufacturer's spares parts by qualified staff.
•
It is forbidden to make any modification or structural repair to the tow bar.
•
The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be checked at regular
intervals. If the tow ball measures less than 49 mm after selected readings across the diameter, the tow ball must be
replaced with a new one.
•
After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.
FITTING INSTRUCTIONS
SAFETY INSTRUCTIONS
USE AND MAINTENANCE
19110 • 1.1 • 11/08/2022
6
Publicité
