Publicité
!
CAUTION: At least two installers are
required due to the weight and size of the
hood.
1. Measure from range top to hood bottom and mark line
A. (26" minimum from range top) .
2. Plum and mark center line.
3. Mark mounting height line B. (16-1/4" from line A)
4. Mark mounting spread from C/L. (8-7/8")
5. Fasten (2) M6 x 1-1/2" screws into studs on line B but
do not tighten all the way. Note: Wood blocking may
need to be added behind the drywall if no studs are
present. Wall anchors may also be used but check
local codes before using wall anchors.
6. Remove the (2) aluminum mesh fi lters.
7. Hang hood onto the mounting screws and hand tighten
each screw. (FIG. A) Secure third M6 x 1-1/2" screw
through inside of hood into wall for extra support. (FIG.
A #2)
8. Center and attach duct cover mounting bracket to wall
just below the ceiling or soffi t using (2) M6 x 1" screws.
9. Install electrical and duct work. Seal duct work with
aluminum duct tape.
10. Power up hood and check for leaks around duct tape.
11. Place telescopic duct covers onto hood and extend
inner (top) duct cover upwards and secure to duct
cover bracket using (2) M4 x 8 screws.
12. Re-install the (2) aluminum mesh fi lters.
* If using hood in recirculating mode you must secure the
air diverter plate onto wall before installing duct work
and duct covers. Turn to page 10 for more details.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
Cable Lock
A cable locking connector (not supplied) might
be required by local codes. Check with local
requirements and codes, purchase and install
appropriate connector if necessary.
Brackets are
pre-installed
2
FIG. A
Cable Lock
9
16-1/4"
26" min
Publicité
