Publicité
General Instructions
Installation: Riser & Hose
Assembly
See separate instructions for
installing no.1 into deck.
1. Shut off water supply and drain
lines.
2. Apply tefl on tape or pipe joint
compound on both ends of no.3.
3. Screw no.3 fi rmly into no.1 by
hand.
4. Slide no.2 down no.3
(about halfway) and
tighten
temporarily.
5. Screw no.6
fi rmly onto no.3,
and fi rmly tighten
no.6 with a wrench.
9
8
7
6
wall bracket
(optional)
3
2
3
1
10
washer
11
2
12
6. Remove no.8 and no.9 from
no.6. Apply tefl on tape or pipe
joint compound to threaded end
of no.8.
10
9
8
7
6
3
7. Screw threaded end of no.9 into
ball end of no.10.
8. Apply a coat of grease to no.7 (if
replacing). Install and tighten no.8
and no.9 into no.6.
Note: Also use step 6 and 8 of this
procedure for replacement of
worn or damaged no.7.
9. Attach end of no.11 to no.10.
(Make sure hose washer is in place).
No.12 should rest in a comfortable
position on no.2 when completely
assembled.
10. Turn on water and check for
leaks.
Optional Wall Bracket
Note: T&S Brass highly
recommends installing a B-0109-
01 Wall Bracket to no.3 with these
Pre-Rinse Units for a more secure
installation. Fit as high as possible
on no.3. Cut off any excess nipple
(unthreaded end) as needed, and
mount to wall.
Publicité
