Publicité
Les langues disponibles
Les langues disponibles
Limited One Year Warranty
T&S warrants to the original purchaser (other
than for purposes of resale) that such product is
free from defects in material and workmanship
for a period of one (1) year from the date of pur-
chase. During this one-year warranty period, if
the product is found to be defective, T&S shall,
at its options, repair and/or replace it. To obtain
warranty service, products must be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other trans-
portation charges of the product to T&S and the
return of repaired or replaced product to the
purchaser are the responsibility of the purchaser.
Repair and/or replacement shall be made within
a reasonable time after receipt by T&S of the
returned product. This warranty does not cover
Items which have received secondary finishing
or have been altered or modified after purchase,
or for defects caused by physical abuse to or
misuse of the product, or shipment of the prod-
ucts.
Any express warranty not provided herein,
and any remedy for Breach of Contract which
might arise, is hereby excluded and disclaimed.
Any implied warranties of merchantability or fit-
ness for a particular purpose are limited to one
year in duration. Under no circumstances shall
T&S be liable for loss of use or any special con-
sequential costs, expenses or damages.
Some states do not allow limitations on how
long and implied warranty lasts or the exclusion
or limitation of incidental or consequential dam-
ages, so the above limitations or exclusions may
not apply to you. Specific rights under this war-
ranty and other rights vary from state to state.
P/N: 098-003157-45 Rev.3
Date: 980814
Drawn: CW
Checked: MAB 12-18-98
Approved: MW 12-17-98
Installation and
Maintenance
Instructions
KETTLE KADDY
B-0180, B-0181, B-0185, B-0190,
B-0195, B-0196
Deutsch:
Installations- und
Wartungsanleitungen
Español:
la Instalación y las
Instrucciones de
Mantenimiento
Français:
les Instructions
d'Installation et
d'Entretien
Publicité
Table des Matières
Manuels Connexes pour T&S KETTLE KADDY B-0180
Sommaire des Matières pour T&S KETTLE KADDY B-0180
- Page 1 Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of pur- chase.
-
Page 2: Exploded View
Exploded View Stanchion Unit Some items are listed for instructional purposes and may not be sold as separate parts. - Page 3 Part Number Guide Stanchion Unit Asm, Stanchion 002847-40 Tube, Stanchion Shield, Expansion 001411-45 Bolt, Shield Valve, Check - 1/2 001332-45 Cap, B-0180, B-0181, B-0195, B-0196 001248-40 Cap, B-0185 001247-40 Riser 001561-25 Locknut 001801-20 Grease Tube...
- Page 4 Exploded View Kettle Kaddy B-0180, B-0181, B-0185, B-0195, B-196 (Models Similar) Some items are listed for instructional purposes and may not be sold as separate parts.
- Page 5 Part Number Guide Kettle Kaddy Assembly Asm, Valve 002900-40 Flange, Cap 1/2 NPSL 001457-40 Mixing Yoke, "Y" B-0180, B-0181 000176-40 Nipple, Close 1/2 NPT 002533-25 Swivel Body, 1/2" (Pre-Rinse) 000592-25 Swivel Body, 1/2" (Nozzle) 000590-25 Asm, Nzl - Dbl Jnt, 18" B-0180, 0181, 0185 002848-40 Nut, Swivel Washer, Swivel...
-
Page 6: General Instructions
General Instructions 4. Screw no.8 into no.5 with running Installation: Stanchion Unit threads up. Use numbers on stanchion unit 5. Remove no.9 from top of no.8. assembly. 6. Slide no.1 and no.2 cover over 1. Shut off water supply and drain piping and put no.6 (or no.7) in lines. - Page 7 General Instructions 10. Place no.6 over no.2. Attach 13. Remove spindle assembly from no.12 (flange cap) onto no.8 and no.1, screw no.1 valve body onto tighten. no.8. flange 14. Apply teflon tape or pipe joint compound to threads of no.8. Place no.1 onto no.8 as far as it will go.
- Page 8 Instruccione Generales 4. Atornille las partes No.8 a dentro de la Instalación: Unidad De Puntal parte No.5 con las roscas mecanica hacia Use los numeros en el ensamble de la arriba. unidad de puntal. 5. Remuéva la parte No.9 de la parte 1.
- Page 9 Instruccione Generales 10. Coloque la parte No.6 sobre la parte Remuéva el ensamble de eje de la No.2. Junte las tapas de reborde No.12 a parte No.1, atornille el cuerpo de la la parte No.8 y aprete. válvula en la parte No.8. 14.
-
Page 10: Instructions Générales
Instructions Générales 4. Visser Nº.8 dans Nº.5 avec les L’Installation: L’élément Stanchion filets courants vers le haut. Utiliser les numéros sur l’élément stanchion. 5. Enlever Nº.9 du haut de Nº.8. 1. Fermer la réserve de l’eau et 6. Faire glisser la couverture Nº.1 et égoutter la tuyauterie. - Page 11 Instructions Générales 10. Mettre Nº.6 sur Nº.2. Attacher les 13. Enlever l’assemblage de la broche capsules de la bride sur Nº.8 et de Nº.1, visser la soupape Nº.1 sur le resserrer. Nº.8. 14. Appliquer le ruban en Téflon ou le la capsule de la bride composé...
-
Page 12: Allgemeine Anleitungen
Allgemeine Anleitungen Installation: Stütze 4. Nr. 8 in Nr. 5 mit dem Gewinde nach oben eindrehen. Die Ziffern auf der Stützgarnitur 5. Nr. 9 vom oberen Teil von Nr. 8 beachten. entfernen. 1. Wasserzufuhr absperren und 6. Die Abdeckung für Nr. 1 und Nr. 2 über Wasserleitungen entleeren. - Page 13 Allgemeine Anleitungen 10. Nr. 6 über Nr. 2 plazieren . Nr. 12 13. Spindelgarnitur von Nr. 1 entfernen, (Flanschkappe) auf Nr. 8 befestigen und Ventilrumpf Nr. 1 auf Nr. 8 schrauben. festdrehen. 14. Teflonband oder Rohrdichtungsmasse Flanschkappe auf das Gewinde von Nr. 8 auftragen. Nr.
- Page 14 RELATED T&S BRASS PRODUCT LINE B-0195 Kettle Filler and Hose Stanchion T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe Travelers Rest, SC 29690 ‘De Veenhoeve’ Phone: (864) 834-4102 Oude Nieuwveenseweg 84...