Using Your Cleaner; Cleaner Maintenance - Hoover FREEJET 2in1 Manuel D'utilisation

NOTE: Use only the charger supplied with your cleaner to recharge.
IMPORTANT: When charging the cleaner the On/Off switch must be OFF.
Keep the charger plugged into the socket at all times. It is normal for the charger to become warm to the
touch when charging.
If the operating times reduces after repeated use let the cleaner run until it stops then recharge for 24
hours, repeat this monthly for best results.

USING YOUR CLEANER

1. Prepare your cleaner for use by releasing the parking lock on the nozzle [5].
2. Turn on your cleaner by pressing the On/Off switch on the handheld cleaning unit (J).
3. Use the nozzle mode selector to change between carpet and hard floor mode [6].
4. To use as a handheld cleaner press the "Push and Go" button to remove the handheld cleaning unit
from the main body [7].
5. The supplied accessories can be used in handheld mode [8].

CLEANER MAINTENANCE

Emptying the Dust Container
Hold the handheld cleaning unit over a bin and pull the bin empty trigger to empty the dust container [9].
Cleaning the Filters
1. Remove the handheld cleaning unit from the main body [7].
2. Press the bin release button and remove the dust container [10].
3. Remove the filter and shroud from the dust container [11].
4. Wash the filter and shroud in lukewarm water. Once thoroughly dry return them to the dust container.
NOTE: Do not use hot water or detergents when cleaning the filters.
damaged, fit a genuine Hoover replacement. Do not try and use the product without a filter fitted.
End of Product Life Battery Disposal
If your cleaner is to be disposed ok, the batteries should be removed. Used batteries should be taken to a
recycling station and not disposed of with household waste.
IMPORTANT: Always fully discharge the batteries before removal.
1. Run the unit until the batteries are flat.
2. Remove the handheld unit from the main body [7].
3. Press the bin release button and remove the dust container [10].
4. Remove 6 screws and to open the handheld cleaning unit [12].
5. Remove the Battery/Motor housing and disconnect the cables [12].
6. Remove the batteries from the housing [12].
NOTE: Should you experience any difficulties in dismantling the unit or for more detailed information
about treatment, recovery and recycling of this product, please contact your local city office or your
household waste disposal service.
In the unlikely event of the filters becoming
7
GB