Publicité
▶
tWTR
Mnmum tme nterval between the end of wrte data burst and the start of a col-
umn-read command. It allows I/O gatng to overdrve sense amplfiers before read
command starts.
▶
tRRD
Specfies the actve-to-actve delay of dfferent banks.
▶
tRTP
Tme nterval between a read and a precharge command.
▶
tFAW
Ths tem s used to set the tFAW (four actvate wndow delay) tmng.
▶
tWCL
Ths tem s used to set the tWCL (Wrte CAS Latency) tmng.
▶
tCKE
Ths tem s used to set the tCKE tmng.
▶
Advanced Channel 1/ 2 Tmng Configuraton
Press <Enter> to enter the sub-menu. And you can set the advanced memory tmng
for each channel.
▶
tRRDR/ tRRDD/ tWWDR/ tWWDD/ tRWDRDD/ tWRDRDD/ tRWSR
These tems s used to set the memory tmngs for memory channel 1/ 2.
▶
GT OverClockng
Ths tem allows you to enable/ dsable the overclockng of ntegrated graphcs.
▶
GT Rato
Ths settng controls the rato of ntegrated graphcs frequency to enable the ntegrated
graphcs to run at dfferent frequency combnatons.
▶
VDroop Control
Ths tem s used to select the VDroop control mode.
▶
CPU Vcore/ CPU IO/ DRAM Voltage/ GPU Voltage/ CPU SA/ CPU PLL Voltage/
DDR_VREF_CA_A/ DDR_VREF_CA_B/ DDR_VREF_DA_A/ DDR_VREF_DA_B/ PCH
1.05
These tems are used to adjust the voltage of CPU, Memory and chpset.
▶
Current CPU Vcore/ Current CPU IO/ Current DRAM Voltage/ Current CPU SA
These tems show current CPU Vcore/ CPU IO/ DRAM/ CPU SA voltage. Read-only.
▶
Overclockng Profile
Press <Enter> to enter the sub-menu.
▶
Overclockng Profile 1/ 2/ 3/ 4/ 5/ 6
Press <Enter> to enter the sub-menu. In the sub-menu, these tems are used to save
the current settngs, and you can to load the settngs from the stored profile.
▶
OC Retry Count
When overclockng has faled, settng ths tem as [1, 3] wll allow system to reboot
1/ 3 tmes wth the same overclocked configuraton. If overclockng has faled every
tme, the system wll restore the defaults.
En-29
Publicité
